We calculate the BTU requirement for each room based on dimensions, insulation levels, and window areas. Chatham's exposed position means properties often need 10-15% higher output than standard calculations suggest.
We plan the most efficient pipe routes from your existing heating system to new radiator positions. In Victorian terraces common around Chatham town centre, we often run pipes under floorboards to avoid surface mounting.
Before installation, we isolate the heating circuit and drain down the relevant section of pipework. We use drain points at the lowest parts of the system and release air from the highest points for complete water removal.
We fix radiator brackets to solid walls using appropriate fixings for the wall type. All connections use compression fittings or push-fit joints with pipe inserts. New installations include thermostatic radiator valves as standard.
After connection, we refill the system through the filling loop, bleed all radiators, and balance the system for even heat distribution. We check boiler pressure and operation, then test all new radiators reach full temperature.
